Concrete & Paving Clear Protective Sealer Matt
About Concrete & Paving Clear Protective Sealer Matt
Areas to use
Surfaces
Ideal for stone and paving paths, steps, garage floors and driveways where you want to protect the surface but retain the natural look.
NOTE: Due to slip risk do not apply to gradients greater than 1:8 or
angles steeper than 7° even when anti slip additive is used.
If unsure about your gradient please contact Dulux Help & Advice AUST 13 25 25, NZ 0800 800 424.
Brush, roller
1. Stir well before and during application with a flat paddle using an up and down scooping action.
2. Mask all adjacent surfaces that are not needed for the application.
3. Use a brush to apply to any edges and hard-to-reach places.
4. Use a roller to apply 1st coat evenly across the surface.
5. Work in small sections, slightly overlap the previous section to minimize raised edges.
6. Gently go over the surface in the same direction with an unloaded roller using minimal pressure to give a smooth consistent finish.
7. Allow to fully dry before applying the 2nd coat.
NOTE: For increased slip resistance, particularly around wet areas, pool surrounds and steps, please add Dulux Concrete and Paving Anti-Slip Additive.
Unused paint
Do not pour leftover paint down the drain.
Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz
Empty paint containers
Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.
Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first.
Do not reuse container unless thoroughly decontaminated.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz
