Autoshield Plastic Primer

For best results, avoid spraying in low temperatures (less than 15°C) or high humidity.

It is recommended to wet sand the surface with 600 grit sandpaper prior to application. The surface must be clean and dry, free from grease, rust and dirt. Clean with wax and grease remover.

Before spraying: Shake can for at least 2 minutes or until the mixing ball rattles inside the can. For best results, avoid spraying in low temperatures (less than 15°C) or high humidity.

Application: Hold the can upright approximately 20–25cm from the surface. To ensure compatibility, test spray on an inconspicuous area. Use smooth, even strokes parallel to the surface. Apply several light mist coats rather than 1 heavy coat to avoid runs and sags. Apply 1–2 light coats and allow 15 minutes before applying a second Dulux® AutoShield™ Primer or Topcoat.

After spraying: Prevent nozzle blocking by turning the can upside down and spraying until clear gas emerges. Wipe the front of nozzle clean. Clean up any overspray while it is still wet using general purpose thinner. 

Spray unwanted paint onto newspaper, allow to dry and dispose of remaining contents/container in accordance with local, regional, national and international regulations.

If can becomes rusted or damaged dispose of carefully – obtain instructions from our website
or 24hr Emergency Response Number.