FASTFINISH™

Ensure all surfaces are clean and dry prior to application. Brush down to remove dust. Thoroughly stir all products with a broad flat stirrer prior to application. Previously painted surfaces, except cement sheets, must be sanded to remove loose, peeling, flaking or chalky paint. Sand all gloss and semi gloss surfaces to a dull finish and wipe down with a damp cloth to remove surface dust. Spot prime bare areas.

Spray only.

Tip size: 0.019"-0.021"

Pressure: 2000-2800 PSI

Approximately 5m² per litre

Water.

Not usually required, but can be thinned with up to 100ml water per litre if necessary.

Drying times on a day of about 25°C

Touch dry: 2 hours Sand: 8 hours then recoat

Flat

Can be used on paper-faced plasterboard, MDF, masonry and suitably primed interior timber. Stir well before use. Apply one coat of Dulux Professional® FASTFINISH™ Undercoat & Ceiling Flat by airless spray to all chosen substrates. For ceilings, apply a second coat of Dulux Professional® FASTFINISH™ Undercoat & Ceiling Flat by spray as the finished coat. Back-rolling of the second coat may be performed to achieve the desired finish. For all areas other than ceilings, apply the suitable topcoats to finish. Please note that in each instance the first coat should be sufficiently dry before applying subsequent coats. Please note that Dulux does recommend the need to back-roll the ceiling to avoid glancing light issues. Learn more about spraying and back-rolling from the Dulux Technical Advice team.

Spray

Tip size: 0.0015"-0.0019"

Pressure: 2000-2300 PSI

Approximately 10m² per litre depending on the porosity of the surface.

Water.

Not required.

Touch dry: 30 minutes

Recoat: 2 hours

Flat

Ensure all surfaces are clean and dry prior to application. Brush down to remove dust. Thoroughly stir all products with a broad flat stirrer prior to application. Previously painted surfaces, except cement sheet, must be sanded to remove loose, peeling, flaking or chalky paint. Sand all gloss and semi gloss surfaces to a dull finish and wipe down with a damp cloth to remove surface dust. Spot prime bare areas. Please ensure all areas are masked up prior to application. This product is formulated with DryFall properties, which when applied to ceilings of minimum 2.7 metres in height allows the paint to dry to a powder and fall to the ground for easy clean up.

Spray

Tip size: 0.015"-0.019"

Pressure: 2000-2400psi

Approximately 14m² per litre.

Water.

Not usually required, but can be thinned with up to 100ml water per litre if necessary.

Drying time on a day of about 25°C

Touch Dry: 15 minutes

Re-coat: two hours

Semi gloss, Gloss

Ensure all surfaces are clean and dry prior to application. Brush down to remove dust. Thoroughly stir all products with a broad flat stirrer prior to application. Previously painted surfaces, except cement sheets, must be sanded to remove loose, peeling, flaking or chalky paint. Sand all gloss and semi gloss surfaces to a dull finish and wipe down with a damp cloth to remove surface dust. Spot prime bare areas.

Spray, roller or brush

Tip size: 0.08" -0.012" Pressure: 1500-1700 PSI

Tip size: 0.08" -0.012"

Pressure: 900-1000 PSI

Approximately 16m² per litre.

Water.

Not usually required, but can be thinned with up to 100ml water per litre if necessary.

Drying times on a day of about 25°C

Touch dry: 30 minutes

Recoat: 2 hours under cool or humid conditions allow longer times. Ensure temperature is above 10°C during application and drying.