Autoshield Acrylic Lacquer Gloss Clear
About Autoshield Acrylic Lacquer Gloss Clear
Dulux® AutoShield™ Acrylic Lacquer Clear Coat is ideal for use as a final coat on automotive parts and panels. It can be used on Dulux® AutoShield™ Topcoats such as Acrylic Lacquer and Wheel Coat, as well as sound, previously painted solvent-based paints.
Downloads
At a glance
- Fast drying: touch dry in 10 mins
- Good coverage: up to 1m2
- Ideal for car parts
- Use on primed metal and plastic automotive surfaces and sound, previously painted surfaces
Areas to use
Precautions and limitations
For best results, avoid spraying in low temperatures (less than 15°C) or high humidity.
Previously Painted Surfaces
The surface must be clean and dry, free from grease, rust and dirt. Clean with wax and grease remover.
Airless/Conventional Spray
Before spraying: Shake can for at least 2 minutes or until the mixing ball rattles inside the can. For best results, avoid spraying in low temperatures (less than 15°C) or high humidity.
Application: Hold the can upright approximately 20–25cm from the surface. To ensure compatibility, test spray on an inconspicuous area. Use smooth, even strokes parallel to the surface. Apply several light mist coats rather than 1 heavy coat to avoid runs and sags. Allow 5 minutes flash off between coats.
After spraying: Prevent nozzle blocking by turning the can upside down and spraying until clear gas emerges. Wipe the front of nozzle clean. Clean up any overspray while it is still wet using general purpose thinner.
Recoating: When a second coat of Dulux® AutoShield™ Acrylic Lacquer Clear Coat is required, re-coat after 24 hours.
Unused paint
Spray unwanted paint onto newspaper, allow to dry and dispose of remaining contents/container in accordance with local, regional, national and international regulations.
If can becomes rusted or damaged dispose of carefully – obtain instructions from our website
or 24hr Emergency Response Number.
